Evolis Avansia Uživatelská příručka stáhnout pdf (Strana 23)

Optimizing transfer conditions

In order to optimize the transfer quality you can change the Retransfer settings according to your card type.

Thanks to the LCD Panel or the printer driver you can select the card type, then the transfer speed and the transfer temperature.

Switch from Normal Mode to User Mode (see section 4-1b).

Press the Key until [Card Setup] is displayed. Press the SET Key.

Confirm that [Card Type] appears. Press the SET Key.

Change the settings by using the t/s Keys:

PVC (0.76mm)

PET(0.76mm)

PET-G -0.76mm)

If [CARD 1-3] is selected, use the t/s Keys and the SET Key to select the transfer speed and transfer temperature:

l left value: transfer speed.

The higher the value, the higher the transfer speed is fast.

l Right value: transfer temperature.

The higher the value, the higher the transfer temperature is hot.

The factory default setting is [PVC 30mil/0.76].

The factory default transfer speed for [CARD 1-3] is set to [35mm/s].

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 80 81

Žádné komentáře

Evolis Avansia Uživatelská příručka Strana 23